Turf Bumper Kit

Up the style of your ski with this turf bumper kit!

Material is black or purple diamond cut.

Adhesion promoter is included to achieve best install. (Total of 3 pads which is plenty for any hull). Please make sure upon installation that the promotor pad is wet with solution. IF IT IS DRY, STOP YOUR INSTALL AND EITHER ORDER NEW PROMOTER OR CONTACT US).

All contact surfaces (Hull or OEM bumpers) are to be cleaned with mild dish soap solution to degrease (Use a grey scotch brite pad), after washing, wiped with acetone (2 time around using a new rag each time around) before any promoter solution is applied. After washing blow dry and let air dry (In sun if possible) until you are sure no water is trapped in the bumper inserts or the rivet holes if you removed the stock bumpers. Apply promoter AS YOU GO not around the whole ski at once. 

For best results please place the turf strips in the sun to unroll. Once the strips are dead flat the product can be applied. If you are trying to apply the strip rolled up it will lift causing bad adhesion.

Once the product is applied place ski in sun. After 30 min to an hour walk around the ski squeezing the turf to the surface. DO NOT USE CLAMPS!!! This will cause the turf to buckle causing the center it to lift due to the force being applied on the top and bottom only from a clamp. If you have any questions please dont hesitate to email us before installation.

This is on our personal rec and race boats and we have zero lift even after 2 years.

Please allow 3-5 days to ship.